4.9 (748) · $ 7.00 · In stock
In stock, ready to ship. The Filastruder melt filter is designed to keep contaminants out of your newly produced filament by filtering the polymer just before it leaves the nozzle. Note that for use with printers having a nozzle size 0.5mm or smaller, it is recommended that a melt filter nozzle is used with the Filastruder to remove any dust/debris from the polymer. It uses a 250 micron wire mesh filter, and has 75sqmm of effective filtration area. It is CNC machined out of brass. I have tested this final revision for over 2000 hours of extrusion, with no measurable decline in output rate. Because the local velocity of the polymer at the screen pack is so low, output rate is not diminished until the filter is nearly full of contaminants. This melt filter is completely reverse compatible with all
Filastruder filament extruder for 3D printing. (1.75mm nozzle). another time waster. Dangerous, don't know.
The potential of converting plastic waste to 3D printed products in Sub-Saharan Africa - ScienceDirect
forsinke Tørke Udvidelse filter nozzle Kommandør lava Takke
forsinke Tørke Udvidelse filter nozzle Kommandør lava Takke
Human exposure to metals in consumer-focused fused filament fabrication (FFF)/ 3D printing processes - ScienceDirect
Precious Plastic - V3.0 Need Feedback - Dave Hakkens
PDF) Human exposure to metals in consumer-focused fused filament fabrication (FFF)/ 3D printing processes
forsinke Tørke Udvidelse filter nozzle Kommandør lava Takke
Introducing the Melt Filter Nozzle
An introduction to DIY filament extrusion and extruders
forsinke Tørke Udvidelse filter nozzle Kommandør lava Takke
The potential of converting plastic waste to 3D printed products in Sub-Saharan Africa - ScienceDirect